Specifications — DVS 100/150 Digital Video Scalers
Video input
Number/signal type ................... Both models............................. 1 component video (Y, R-Y, B-Y), 1 S-video,
1 composite video
DVS 150 only ........................... 1 RGBHV, RGBS, RGsB pass-through
Connectors.................................... 3 BNC female .......................... component video
1 4-pin mini-DIN female ...... S-video
1 BNC female .......................... composite video
1 15-pin HD female ............... RGB pass-through (DVS 150 only)
Nominal level(s) .......................... Analog — 0.7V to 1.0V p-p
Impedance .................................... 75 ohms
Vertical frequency ....................... 50 Hz to 60 Hz (does not apply to DVS 150 pass-through)
Video output
Number/type/format ................ 1 scaled RGBHV, RGBS, RGsB
1 scaled RGBHV or pass-through RGBHV/RGBS/RGsB
Connectors.................................... 6 BNC female
1 15-pin HD female
Nominal level............................... 0.7V p-p
Impedance .................................... 75 ohms
Vertical frequency ....................... 56 Hz, 60 Hz or 75 Hz
Scaled VGA resolution ............... 640x480, 800x600, 832x624, 848x480, 852x480, 1024x768, 1280x768, 1280x1024,
1360x765, HDTV 480p, 720p and 1080p
Sync
Input type ..................................... DVS 150 only ........................... RGBHV, RGBS, RGsB
Output type .................................. RGBHV, RGBS, RGsB
Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level ................................. TTL — 5.0V p-p
Output impedance ...................... 75 ohms
Polarity .......................................... Positive or negative (switch-selectable)
Control/Remote — decoder/scaler
Serial control port........................ RS-232, 9-pin female D connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Pin configurations ....................... 1 = input 1 select
2 = TX
3 = RX
4 = input 2 select
5 = GND
6 = input 3 select
7 = input 4 select (DVS 150 only)
Contact closure ............................ 9-pin female D connector
Program control........................... Extron’s control program for Windows®
Extron’s Simple Instruction Set™ – SIS™
1-2
DVS 100, DVS 150 Specifications
|